Category: Plastic Parts

Plastic Printed Parts Description

Plastic Parts

List of details pertaining to the printed plastic parts.

Download the STL Pack here: XenoCube STL Pack

Note: Depending on on the printer printing the parts, its always recommended to predrill the holes on all parts.

Parts list:

  • 12to5v Inverter and Heatbed Relay Mount.stl
  • 24vTo12 Inverter Mount.stl
  • 8mm Threaded Rod Stay.stl
  • 90 Wire Clamp.stl
  • Cam Mount.stl
  • Door Handle.stl
  • Door Hinge.stl
  • Filament Spool Holder.stl
  • Frame Corner Foot Bracket.stl
  • Frame T Bracket.stl
  • Heatbead Wire Holder.stl
  • Heatbed Plate Mount.stl
  • Hotend Ducting Back.stl
  • Hotend Ducting Fan Mount.stl
  • Hotend Ducting Upper.stl
  • HotEnd Ducting.stl
  • LED Light Clamp.stl
  • MKS Controller Board Mount Leftside.stl
  • MKS Controller Board Mount Rightside.stl
  • Power Supply Mount Left.stl
  • Power Supply Mount Right.stl
  • Power Switch Mount.stl
  • Raspberry Pi Mount.stl
  • Tension Spring Cap Extruder.stl
  • Terminal Block Bracket.stl
  • Top Corner Cover Plate.stl
  • Top Middle Cover Plate.stl
  • Top Plate.stl
  • Top Slider Corner with Wiring.stl
  • Wire Clamp 6mm Hole Ziptie.stl
  • Wire Clamp 90 Outside.stl
  • X Axis Carriage.stl
  • X Axis Idler.stl
  • X Axis Motor Mount.stl
  • XY Endstop.stl
  • Y Axis End Stop.stl
  • Y Axis Motor Mount.stl
  • Y Axis Smooth Rod Bracket.stl
  • Z Axis Bed Mount.stl
  • Z Axis Motor Mount.stl
  • Z Endstop.stl
  • Z-Axis idler.stl

What Tools will I need?

The following is a list of common tools needed to assemble XenoCube.

  1. Prepping Parts:
    • Drill Bit Set – Including 8mm, 5mm, and 3mm drill bits. Drill the holes on the plastic parts.
    • Metal Chop Saw – Extrusion Bar, Drill Rod, and Threaded Rod needs to be cut.
  2. Frame Construction:
    • Bit Driver – Recommended to save your wrists.
    • Hex Bit Set – Including 3mm Hex, 5mm, Hex, Philips, and Flat head bits.
    • Pliers – Diagonal, and Needle Nose.
  3. Wiring:
    • Wire Stripper – Prepping wire ends.
    • Soldering Iron – Connecting wires together.
    • Wire Crimpers – Connections to PSU and Terminal Blocks.
    • Voltage Meter – Good for checking connections, resist, and well voltages.
  4. Software:
    • Computer – Needed for imaging Raspberry Pi SD card.